+ Site Statistics
+ Search Articles
+ PDF Full Text Service
How our service works
Request PDF Full Text
+ Follow Us
Follow on Facebook
Follow on Twitter
Follow on LinkedIn
+ Subscribe to Site Feeds
Most Shared
PDF Full Text
+ Translate
+ Recently Requested

Method of setting the knife and pressure bar in veneer rotary cutting



Method of setting the knife and pressure bar in veneer rotary cutting



Przemysl drzewny 29(3): 20-23




Please choose payment method:






(PDF emailed within 1 workday: $29.90)

Accession: 016364705

Download citation: RISBibTeXText


Related references

Distribution of cutting stress on the rake face of the knife in veneer cutting by restricted knife-veneer contact length method. Mokuzai Gakkaishi Journal of the Japan Wood Research Society 20(11): 528-537, 1974

Cutting of rotary veneer. (1). Effect of position of nose-bar to knife edge (No. 1). Bull. For. Exp. Sta., Meguro, Tokyo. 203, 131-71, 1967

A note on setting the knife angle for rotary veneer peeling. Malay. Forester. 31: 3, 187-93, 1968

Determining the optimum clearance angle of the knife in the rotary cutting of veneer of Fagus sylvatica and Abies alba. Industria Lemnului 24(10): 398-402 + smries., 1973

Veneer cutting of softwoods IV. Influence of varied depths of cuts, cutting directions to pith and shapes of knife edges on the veneer quality. Mokuzai Gakkaishi = Journal of the Japan Wood Research Society 39(9): 1005-1011, 1993

Effects of sliding velocity and inclination angle on the cutting force in veneer slicing by feeding the knife to the workpiece during the sliding of the knife in the direction parallel to the cutting edge. Mokuzai Gakkaishi Journal of the Japan Wood Research Society 32(9): 677-684, 1986

Spin-out of veneer blocks during rotary cutting of veneer. USDA Forest Service Research Paper, Forest Products Laboratory, Madison (FPL 278): 23, 1976

Behavior of cutting surfaces cell walls at the cellular level in veneer cutting part 1 effects of knife angle upon cutting resistance and ratio of u shaped cells. Bulletin of the Fukuoka University of Education Part III Natural Sciences 22: 305-315, 1972

Fundamental studies on mechanisms of veneer cutting. I. On behavior of deflection caused in wood by pressure bar compression. II. An analysis on development of dynamic equilibrium condition in veneer cutting. J. Jap. Wood Res. Soc, 17: 3, 96-110, 1971

Effects of nosebar figure in the thick veneer cutting. (1). Cutting load on both the knife and the bar. Mokuzai Kogyo Wood Industry 32(4): 15-19, 1977

Veneer cutting of softwoods I. Cutting of knots by a knife with a face microbevel. Mokuzai Gakkaishi = Journal of the Japan Wood Research Society 37(12): 1135-1143, 1991

Studies on rotary lathe cutting. Report (III). Effect of cutting conditions on the quality of Basswood, Aspen and Tulip tree veneer.. Bull. For. Exp. Sta., Meguro, Tokyo. 119, 67-78, 1960

The specific cutting force as a function of the blunting of knife edges in rotary cutting.. Holztechnologie, Dresden. 4: 2, 158-62, 1963

The influence of wear on the forces acting on the knife of a rotary-veneer lathe. Industria Lemnului 24(11): 451-456 + smries., 1973

The rotary cutting of veneer.. Pap. ja Puu. 44: 9, 439-57, 1962