Dynamic and pseudodynamic modelling of transient and periodic CSTR operation
Klusacek, K.; Hudgins, R.R.; Silveston, P.L.
Canadian Journal of Chemical Engineering 67(3): 516-520
1989
ISSN/ISBN: 0008-4034 Accession: 074970269
PDF emailed within 1 workday: $29.90
Related References
Gogova, Z.; Hanika, J. 2009: Dynamic modelling of glucose oxidation with palladium catalyst deactivation in multifunctional CSTR: Benefits of periodic operation Chemical Engineering Journal (1996) 150(1): 223-230Matsubara, M.; Nishimura, Y.; Takahashi, N. 1973: Periodic operation of CSTR-I idealized control Chemical Engineering Science 28(7): 1369-1377
Matsubara, M.; Nishimura, Y.; Takahashi, N. 1973: Periodic operation of CSTR - II practical control Chemical Engineering Science 28(7): 1379-1385
Hunag, Y.J.; Lee, P.I.; Schwarz, J.A.; Heydweiller, J.C. 1985: Analysis of the CSTR approximation under transient operation Chemical Engineering Communications 39(1-6): 355-370
Payri, F; Benajes, J; Galindo, J; Serrano, J R 2002: Modelling of turbocharged diesel engines in transient operation. Part 2: wave action models for calculating the transient operation in a high speed direct injection engine Proceedings of the Institution of Mechanical Engineers Part D Journal of Automobile Engineering 216(6): 479-493
Nikolić, D.; Seidel-Morgenstern, A.; Petkovska, M. 2014: Nonlinear frequency response analysis of forced periodic operation of non-isothermal Cstr using single input modulations. Part I: Modulation of inlet concentration or flow-rate Chemical Engineering Science 117: 71-84
Nikolić, D.; Seidel-Morgenstern, A.; Petkovska, M. 2015: Nonlinear frequency response analysis of forced periodic operation of non-isothermal Cstr with simultaneous modulation of inlet concentration and inlet temperature Chemical Engineering Science 137: 40-58
Gray, P.; Kordylewski, W. 1985: Dynamic responses to perturbations in the non-isothermal, continuous-flow stirred-tank reactor (Cstr)II. Nonadiabatic operation: the general case Chemical Engineering Science 40(9): 1703-1707
Bermudez, V.; Serrano, J. R.; Piqueras, P.; Garcia-Afonso, O. 2011: Assessment by means of gas dynamic modelling of a pre-turbo diesel particulate filter configuration in a turbocharged HSDI diesel engine under full-load transient operation Proceedings of the Institution of Mechanical Engineers Part D Journal of Automobile Engineering 225(9): 1134-1155
Nikolić, D.; Seidel-Morgenstern, A.; Petkovska, M. 2014: Nonlinear frequency response analysis of forced periodic operation of non-isothermal Cstr using single input modulations. Part Ii: Modulation of inlet temperature or temperature of the cooling/heating fluid Chemical Engineering Science 117: 31-44
Li, C.; Hudgins, R.R.; Silveston, P.L. 1985: Modelling of non-stationary ammonia synthesis kinetics over an iron catalyst. II. Modelling results of forced feed composition in periodic operation and for step-changes Canadian Journal of Chemical Engineering 63(5): 803-809
Gray, P.; Kordylewski, W. 1985: Dynamic responses to perturbations in the non-isothermal CSTR: times to ignition and times for temperature decay. I: Adiabatic operation Chemical Engineering Science 40(8): 1577-1583
So, S.Y.; Oda, A.; Sugawara, H.; Sakai, Y. 2002: Two-dimensional modelling of CF4 rf plasmas: periodic steady state, transient response after step change of power source voltage, and comparison with one-dimensional modelling Journal of Physics. D, Applied Physics 35(22): 2978-2987
Erdogan, G.U.L.A.R.I.; Zhou, X.; Sze, C. 1995: Catalytic oxidation of carbon monoxide under periodic and transient operation Catalysis Today 25(2): 145-157
Oya Mercan; James, M. Ricles 2008: Stability analysis for real-time pseudodynamic and hybrid pseudodynamic testing with multiple sources of delay Earthquake Engineering and Structural Dynamics 37(10): 1269-1293
Ziegelhoeffer A.; De Jong J.W.; Ferrari R.; Turi Nagy L. 1982: Modelling forced periodic operation of catalytic reactors Chemical Engineering Science 37(12): 1797-1805
Dodds, R.; Hudson, P.I.; Kershenbaum, L.; Streat, M. 1973: The operation and modelling of a periodic, countercurrent, solidliquid reactor Chemical Engineering Science 28(6): 1233-1248
Rakopoulos, C.D.; Giakoumis, E.G.; Michos, C.N. 2007: Quasi-linear versus filling and emptying modelling applied to the transient operation of a turbocharged diesel engine : Combustion modelling and experiments in internal combustion engines International Journal of Vehicle Design 45(1-2): 150-170
Chiao, L.; Rinker, R.G. 1987: On the use of approximations in the modelling of plug-flow reactors under periodic operation Chemical Engineering Communications 57(1-6): 153-165
Ellam, D.J.; Bullough, W.A.; Atkin, R.J. 2005: Modelling the flow of an electrostructured fluid in transient operation Proceedings of the Institution of Mechanical Engineers. Part A. Journal of Power and Energy 219(1): 61-76