Suspension-to-membrane-wall heat transfer in a circulating fluidized bed combustor
Luan, W.; Bowen, B.D.; Lim, C.J.; Brereton, C.M.H.; Grace, J.R.
International Journal of Heat and Mass Transfer 43(7): 1173-1185
2000
ISSN/ISBN: 0017-9310
Accession: 078092456
PDF emailed within 1 workday: $29.90
Related References
Golriz, M.R. 1996: Suspension-to-wall heat transfer in a 12-MWth circulating fluidized-bed combustor International Journal of Energy Research 20(7): 569-579Ziegelhoeffer A.; De Jong J.W.; Ferrari R.; Turi Nagy L. 1989: Suspension-to-Surface heat transfer in a circulating-fluidized-bed combustor Aiche Journal 35(10): 1685-1691
Xie, D.; Bowen, B.D.; Grace, J.R.; Lim, C.J. 2003: A three-dimensional model for suspension-to-membrane-wall heat transfer in circulating fluidized beds Chemical Engineering Science 58(18): 4247-4258
Winaya, N.S.; Basu, P.; Reddy, B.V. 2003: Experimental investigations on heat transfer from suspension to impact separators in the riser column of a circulating fluidized bed combustor International Journal of Heat and Mass Transfer 46(1): 71-75
Gnanapragasam, N.V.; Reddy, B.V. 2008: Numerical modeling of bed-to-wall heat transfer in a circulating fluidized bed combustor based on cluster energy balance International Journal of Heat and Mass Transfer 51(21-22): 5260-5268
Nirmal Vijay, G.; Reddy, B.V. 2005: Effect of dilute and dense phase operating conditions on bed-to-wall heat transfer mechanism in a circulating fluidized bed combustor International Journal of Heat and Mass Transfer 48(16): 3276-3283
Wang, X.S.; Gibbs, B.M.; Rhodes, M.J.; Geldart, D. 1996: Convective wall-to-suspension heat transfer in circulating fluidized bed risers Aiche Journal 42(8): 2112-2117
Wang, X.S.; Gibbs, B.M.; Rhodes, M.J.; Geldart, D. 1996: A correlation for the suspension-to-wall heat-transfer coefficient in circulating fluidized beds Industrial and Engineering Chemistry Research 35(10): 3822-3823
Somjun, J.; Chinsuwan, A. 2018: Effect of transverse rib on heat transfer between circulating fluidized bed and membrane fins of water wall membrane tubes Powder Technology 332: 178-187
Nag, P.K.; Sallam Ali, M.; Reddy, B.V. 1993: Heat transfer in a circulating fluidized bed combustor burning indane gas Indian Journal of Technology 31(1): 9-12
Gui Young Han; Yong Jun Cho 1999: Radiative heat transfer in a circulating fluidized bed coal combustor Powder Technology 102(3): 266-273
Anusorn Chinsuwan; Animesh Dutta 2009: An investigation of the heat transfer behavior of longitudinal finned membrane water wall tubes in circulating fluidized bed boilers Powder Technology 193(2): 187-194
Yumin, C.H.A.N.G.; Yufu, L.O.; Mayyenn, C.H.E.N. 1990: Heat transfer measurements of a 1.0 ton-steam/HR circulating fluidized-bed combustor burning Taiwan coals Particulate Science and Technology 8(3-4): 199-208
Jin Hee Jeon; Sang Done Kim; Seung Jae Kim; Yong Kang 2008: Combustion and heat transfer characteristics in a square internally circulating fluidized bed combustor with draft tube Fuel 87(17-18): 3710-3713
Ozen, G.; Aydin, F.; Selçuk, N. 2016: Radiative Heat Transfer in the Dilute Zone of an Air-Fired Circulating Fluidized Bed Combustor and Its Oxy-Fired Retrofit Combustion Science and Technology 188(4-5): 730-744